PDA

View Full Version : sorry for making all of these threads but i really need help

Mr. Pickle
11-20-2005, 09:48 PM
I'm going to get some parts that i need to tomorrow so i need to know a few things.

when going from a sansamp rbi to a QSC 850, is it possible to plug the sansamp into both channels on the qsc or can you only use one of the input channels? (i havent got mine yet so i dont know)
Sade
11-20-2005, 09:51 PM
I'm going to get some parts that i need to tomorrow so i need to know a few things.

when going from a sansamp rbi to a QSC 850, is it possible to plug the sansamp into both channels on the qsc or can you only use one of the input channels? (i havent got mine yet so i dont know)

Why would you need to?
naut
11-20-2005, 09:53 PM
hey i just sold my QSC 850 at a pawn shop.

...

yeah i don't know what the point of that was either.
Mr. Pickle
11-20-2005, 10:02 PM
well, i'm not saying i need to, i'm just very ****ing confused on what i need to buy. i'll go through the situation again.

alright, on my cab there is one 15" wired to one 1/4" jack and there are two 10"s wired together to one 1/4". The qsc only has speakon outputs on the back (bare wire crap too but i dont really wanna do that) so i know i have to buy at least one speakon ===> 1/4" adapter.

since the 2nd output channel on the qsc would only send out signal from w/e is plugged into the channel 2 input (right?) do i need to buy a y-adapter of some sort so i can power my cab by just using the channel 1 output?
naut
11-20-2005, 10:04 PM
here pipe, link ready:

http://www.freewebs.com/supernaut/allyourbass.htm
Mr. Pickle
11-20-2005, 10:05 PM
cool thanks
Mr. Pickle
11-20-2005, 10:32 PM
ok, i guess i can end all these threads with 2 questions.

First, on the QSC, if i use parallel, will the signals come out of both output channels even if i only use one input channel?
Sade
11-20-2005, 10:35 PM
ok, i guess i can end all these threads with 2 questions.

First, on the QSC, if i use parallel, will the signals come out of both output channels even if i only use one input channel?

Yes.
Mr. Pickle
11-20-2005, 10:40 PM
alright, almost there.

finally, what will happen, while in parallel mode, if i use bridged mode? (and if i dont use bridged mode?)
Mr. Pickle
11-20-2005, 10:49 PM
nm, i figured it out. thanks for your help sade.

justin, u can close this or w/e